How do I apply pending changes?

Follow

Bruce Christie

February 21, 2019 19:48

From the data tab I see the following:

 

What are the pending changes?  How do I apply them?   I tried rebuilding the cube but that did not change anything.

Thanks,

Bruce

0

• 

  Katie Garrison February 22, 2019 15:52

  Hi Bruce,

  Could you tell us where you are doing the cube builds? Are you doing the build in the Web ECM or the Desktop ECM?

  The reason I ask is because currently Sisense does not sync the cubes post build between the Web ECM and the Desktop ECM. The schema between these two are keep in separate places and not shared among one another.

  As such, successfully building on the Desktop ECM should not update (and thus remove the changes pending banner) on the Web ECM, because it doesn't affect that schema at all. As such we recommend to performing all builds on the same platform.

  Going back to the core issue - if you perform a build on the Web ECM do you continue to see the "Changes Pending" banner post-build?

  Thanks,
  Katie Garrison | Technical Solutions Consultant

  0

  Comment actions Permalink
• 

  Bruce Christie February 22, 2019 15:59

  Thanks for the reply Katie.   

  RE: "Are you doing the build in the Web ECM or the Desktop ECM". I did both and still see the message.

  0

  Comment actions Permalink
• 

  Jeff Oliphant July 17, 2019 13:31

  Is no one from Sisense going to answer this?  I have this problem as well, and no documentation on how to precisely find the cause for this message displaying. 

  0

  Comment actions Permalink
• 

  Jonathan Sabah November 08, 2019 15:42 (Edited November 08, 2019 15:43)

  I have a slightly different question to the above, but it's related to how pending changes are managed in Sisense.

  How do you reset/discard pending changes in the Web ECM?

  Regards

  2

  Comment actions Permalink
• 

  Reporting Millcorp February 21, 2020 03:37

  I too am interested in how you reset/discard pending changes in the Web ECM?

  1

  Comment actions Permalink

Please sign in to leave a comment.